i, i have big problems with skyoneHD streams to decode with ffshow (h264 - libavcodec). i use the latest haali splitter for the transport stream splitting and ffshow as decoder for transcoding to x264. with graphedit i setup filter graphs to use ffdshow, cyberlinks h264 decoder and coreavc. for me ffdshow gives the best picture so i want to go with it. coreavc has still the color issues on these kind of 1080 streams (paff i think). cyberlink has kind of a more blury look. problem is that at some points in the stream there are i think little errors which all the other decoder eat up but only ffdshow chokes on. on older builds there were heavy blocky images on these locations but with the latest builds 850+ ffdshow crashes asking for a jit debugger (i have vs 2005 installed). i have uploaded a little sample of these errors so that you guys can have a look at them. the latest ffdshow build i tried is 890, i set IDCT to auto, encoder workarounds to autodetect, error resilience to compliant and error concealment to none. please have a look, because this is starting to cost very much sleep for me.. sample: http://www.megaupload.com/?d=0Z6EP0RW http://www.mytempdir.com/1205486 (mirror) i posted this issue on the doom9 forums aswell [1] and answered an question if remuxing the stream helps with: yes, but remuxing introduces new errors on other places of the stream due to skipping of frames while demuxing (mplayer, h264to etc. tested, all the same result, so no remuxing is the way i chose). i will upload the sample to the ftp page but it will be 19MB big to show the issue. [1] http://forum.doom9.org/showthread.php?p=950065#post950065